Ducati Diavel Motorcycles Forum banner

Anybody familiar with these?

1K views 3 replies 3 participants last post by  Trev1262 
#1 ·
Replacing my damaged rear brake hose (yes they have been updated), had to remove air box to access one end of hose. Upon removing it found two sensors just laying there, and also this diaphragm just laying there with no hoses attached. Can’t see any hoses that would connect to it, also only have one hose that was connected to tank, looks like it should be three.
Automotive tire Motor vehicle Automotive design Automotive exterior Bag

Automotive tire Product Automotive design Motor vehicle Automotive exhaust
 
See less See more
2
#4 ·
Found an online parts diagram, that pressure sensor that’s just loose should be bolted to bottom of airbox, and that diaphragm is part of emissions, that appears to have been removed. My bike WAS fully dealer serviced until after desmo service was done. I just don’t know if those emissions hoses were removed by dealer or those are only on California models.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top